Arborite cutting tools

Keep the base or middle slightly wider than the upper part of the shrubs. With tall arborvitaes, the goal is to maintain their iconic pyramidal shape. Keep the bottom of the plant wider than the top for light and air penetration. If you are using a ladder to work with really tall plants, wear sturdy boots to secure your footing and exercise extra care to prevent falls. About the author: Jeffrey Douglas is a horticultural hobbyist that loves everything related to plants and gardening.

He specializes in gardens and houseplants. Hello I have a large overgrown arborvitae that needs a serious trim. Would it come back green next year? This post may contain affiliate sales links. Please see my full disclosure policy for details. Notify of. Oldest Newest Most Voted. A straight edge clamped to the Arborite allows for straight cuts, or laminate can be cut free hand following a marked line.

For small projects where only a few pieces are needed, a utility knife can be used to score the back of the Arborite. Run your knife along a metal straight edge, applying steady pressure.

Repeat this scoring cut several times until a bit of a groove develops. Move the cut line so that it is aligned with the edge of the work table and press down firmly to break the Arborite against the table edge, along the scored line you created with the utility knife. For creating seams that will butt up against a wall or other vertical surface, or will be butted to another seamed piece, a rotary tool with a flush cut bit works best.

Again, this can be a small rotary tool with a base, or a router. Clamp a straight-edged board or metal straight edge along the bottom of the Arborite on the seam line. Run your tool so that the bit rides along the edge of the straight edge, making a perfectly straight cut through the material. Drill a hole in each corner big enough to fit your jigsaw blade into. Select a drill bit that is just larger than the blade of your jigsaw. Attach it to your drill and make a hole on the inside of each corner of the cutout so that you can slide the jigsaw in and out at the corners.

However, if you make 4 you can maneuver more easily at the corners. Cut all the way around the lines you made on the masking tape with your jigsaw. Slide the jigsaw blade into the hole at the corner you want to start cutting from. Turn it on and start cutting along the lines until you have separated the cutout from the countertop.

Lift the cutout out and discard it. The mounting lip of the sink will cover up any minor imperfections. Test the sink and make any adjustments until it fits. Lower the sink into the cutout and see if it fits. You are done if it fits into the cutout and the mounting lip rests flat all the way around.

Use your jigsaw to trim off more countertop if you need to to make it fit. Emma Oberlander Interior Designer. Emma Oberlander. First, you can measure the length and width of the space where you will put the laminate countertop. Then, multiply the two measurements to find the size that you need. Yes No. Not Helpful 0 Helpful 0. Include your email address to get a message when this question is answered. You Might Also Like How to.

How to. Interior Designer. Expert Interview. More References About This Article. Co-authored by:. Co-authors: 4. Updated: December 3, Of all saw blades, carbide cuts fast and is safer to use.

A circular saw is best used to make the majority of laminate cuts. A circular saw produces a very straight cut. The circular saw also comes with a guide that clamps onto the Arborite.